Tuning in a new Fob

Decide which side of the fob you wish to tune the gate into left (orange) button 1 or right (green) button 3
Assume for this exercise you are tuning in the orange side
THE ONLY BUTTON ON THE FOB TO PRESS IS BUTTON 1

Turn off gate both sides if it is a pair
Hold down the green button on top of the cabinet and turn gate on using the on/off switch inside the cabinet
Continue holding down the green button on the cabinet for 5 seconds then release
LED on motor board will change from steady to slow flash
press orange button 1
LED on motor board will flash quickly
press orange button 1 again
Press green button on top of cabinet to lock in fob
Press green button on top of cabinet again
Gate should operate – if not press the green button on the cabinet a third time
press the up orange button and down orange button on the fob to check it is tuned in
turn gate off
If operating as a pair repeat this on the other side

NOTE
when starting the process and holding down the green button while turning the gate on at the switch
DO NOT hold down the green cabinet button for to long as if you hold this button down for over 10 seconds before releasing you will wipe all the fobs from the memory
It will then be necessary to pair the gates and tune in all the other fobs.